Archive for March, 2015
My granddaughter spits up a lot and might be starting to teethe. She goes through a lot of bibs. Most bibs are too small, too thin, and the plastic backing rips and tears after multiple trips through the washing machine and dryer. Fastening a bib at the nape of the neck requires a third hand. Velcro is nice, but the hook part sticks to everything in the wash if the dirty bib isn’t closed before it hits the washer. Cheap/fake hook and loop closures lose their “stick” pretty quick. A good bib is large, absorbent, waterproof, adjustable, easy to put on and take off, and easy to wash. Good luck finding one that meets all the criteria. It’s a good thing we can sew!
The “Perfect Bib” Tutorial
2. Trace or photocopy the bib to get the pattern. I used the copy button on my printer and then copied the bib in two sections. Then I taped them together. Two sheets of Sticky Template Plastic covered the pattern with some to spare.
Just peel off the release paper, place the sticky side down on the photocopy, and press. When using two sheets, as in this project, butt the long sides of each sheet together so there are no gaps. Cut two rectangles 1/2″ wide from the leftovers and stick those over the join to keep the template from bending. If I were making just one bib, I would use the paper pattern, but making a sturdy plastic template means I can trace the shape instead of pinning the paper to use as a pattern. It’s faster and more accurate. (Replace the release paper on the sticky part of the template plastic not touching the paper pattern to save it for another time.)
4. Place the plastic template on the wrong side of the PUL fabric and trace with a ball point pen. Easy peasy.
5. Place the PUL fabric on top of bib front, right sides together. You can purchase terrycloth by the yard for the bib front or up-cycle hand and bath towels. The higher quality the terrycloth, the more absorbent the bib. Pin all the way around. (Don’t worry about pin wholes in the PUL fabric. A hot dryer will close them.) Don’t forget to mark an opening through which you will turn the bib right-side out.
6. Sew on the marked line, leaving an opening. I backstitch several times at the beginning and end so the stitches won’t come out when I turn the bib right-side out. Cut 1/4″ from the stitching. Clip inside curves.
7. Turn the bib right-side out and press. Turn under the opening and clip. Baste opening closed.